GUIDE TO CREATE SCATTER FILE FOR YOUR MTK PHONE

0
155

One of the most important ingredient needed at any point in time by anyone who has been unfortunate enough to have their phone way or another bricked is the “scatter file” of the particular phone modelstock rom.  It’s quite small but performs wonders because without it,  chances of bringing back your dead phone to life is close to non existent.  Normally quite small in size in fact typically less than 100kb… {you can basically do quite a lot with your stock scatter file}  this is why it’s important for you to find a way to have it in store for the raining days when your phone decides to finally act up…

Note: Using another smartphone’s scatter file might be counter productive at some point in time especially if you end up flashing a scatter file that is not of your own particular firmware {from frying pan to fire scenario you would have gotten yourself into}.. lols

So below is just the basic steps of creating your own scatter file in couple of minutes on your mtk smartphone using mtkdroidtools.

REQUIREMENTS:

☆ Your  MTK based smartphone
☆ Woring USB Data Cable

☆ ADB VCOM Drivers (normally I use PDAnet). Go here to learn how to install Mediatek Vcom Drivers or you can also plug your Android to your PC to auto detect and install needed drivers. But if your phone drivers was not installed after plugin your device, then goto that link page.

☆ Download MT6577 USB VCOM Driver (W7/Vista/XP) – Download

☆ Download MT6577 USB VCOM Driver (W8) – Download

READ  How To Flash CPB Format Stock Rom To Android Phone Using YGDP Tool

☆ MTK Droid Tools – Download

STEP BY STEP GUIDE TO CREATE SCATTER FILE:

1. Enable USB debugging on your smartphone in settings – developer options.
2. Install the VCOM drivers manually or with PDA net
3. Download, extract, and run the latest version of MTK Droid Tools. (run as admin!)

4. Your phone should be on at this point. Connect the data USB cable to your phone and wait about 10 seconds. Eventually you should see the phone’s information come up.

5. Click ‘blocks map’. A new window should open with all your phone’s block information and where each portion of your firmware is stored on ROM.

6. Click ‘create scatter file’. Navigate to where you want to save it. Save it in a place where you won’t lose it. If you need it for flashing firmware, save it in the folder of the firmware. If you need it for flashing a recovery, save it in the folder with the recovery.

Now you can use your new created scatter to flash your smartphone with sp-flash tools

SEE ALSO: How To Flash/ Install Rom Using Sp Flashtools

LEAVE A REPLY

Please enter your comment!
Please enter your name here